Samsung AC071MN4PKH - Set the Indoor Installation Options(Option to Set for the Installation Site Conditions)

Troubleshooting
4-14
Option No. for an indoor unit address:02XXXX-1XXXXX-2XXXXX-3XXXXX
Option SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
Function Page Mode
Reserved
Use of external
temperature sensor
Use of central
control
Compensation of
the fan RPM
Indication
and
details
Indication Details Indication Details Indication Details Indication Details Indication Details
02
0 Disuse 0 Disuse
0
Disuse
(recessed installation)
1
High-ceiling mode
(recessed installation)
1 Use 1 Use
4
Disuse
(exposed installation)
5
High-ceiling mode
(exposed installation)
Option SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
Function Page
Use of drain
pump
Reserved Reserved Reserved Reserved
Indication
and
details
Indication Details Indication Details
1
0 Disuse
1Use
2
Use with
3 minute
delay
Option SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
Function Page
Use of external
control
Setting the output of
external control
S-Plasma ion Buzzer control
Maximum filter
usage time
Indication
and
details
Indication Details Indication Details Indication Details Indication Details Indication Details Indication Details
2
0 Disuse 0
thermo
on
0 Disuse 0
Use of
buzzer
2
1000
hours
1
On/Off
control
1
Operation
on
1Use1
Disuse of
buzzer
6
2000
hours
2
Off
control
Option SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
Function Page
control with
remote control
Heating setting
compensation
No function
assigned
No function
assigned
Cycle time of
Swing
Indication
and
details
Indication Details Indication Details Indication Details Indication Details
3
0 or 1 Indoor 1 0 Disuse
0
34 seconds
(default)
2 Indoor 2 1 2°C
1 30 seconds
3 Indoor 3
25°C
4 Indoor 4
2 38 seconds
1. Make sure that the power is supplied to the indoor unit.
If the indoor unit is not plugged in, it must include a power supply.
2. Make sure that the panel is connected to the indoor unit so that it can receive options
3. Set the functional options of indoor units, by referring to the following table and by following the steps in
Common steps for setting the addresses and optionson page 16.
t5IFGVODUJPOBMPQUJPOTPGJOEPPSVOJUTBSFTFUUPCZEFGBVMU
t5IF4&(PQUJPO*OEJWJEVBMDPOUSPMXJUISFNPUFDPOUSPMBMMPXTZPVUPDPOUSPMNVMUJQMFJOEPPSVOJUTJOEJWJEVBMMZCZVTJOHUIFSFNPUF
control.
4-1-5. Set the indoor installation options(Option to set for the installation site conditions)
Indoor unit
F
1
F
2
LN