81
• Do not let the power cable come into contact with the pipes inside the outdoor unit. If the power supply
cable touches the pipes, the vibration of the compressor is transferred to the pipes and can damage the
power supply cables or pipes, creating the danger of re or explosion.
• Make sure that the place where the sheath of power supply cable is removed is inside the power supply
box. If it is impossible, you should connect the protection tube for power cable to the power supply box.
• After arranging the power cable into the power supply box, tighten the cover.
CAUTION
Connect the ring terminal of 3 phase cable
1. Cut the power cable to an appropriate length and connect it with the
solderless terminal.
2. After connecting the power cable to the terminal as seen in the
illustration, x it with cable tie.
3. Fix the housing, which has an insulator, to the terminal board.
Fixing the ground cable
Connect the ground cable to the grounding hole inside the power supply
box.
Grounding
DVM S HE_IM_DB68-05461A-08_EN.indd 81 2017-03-24 오후 1:38:39
To Next Page
Loading...
