12
Drain hose installation
Care must be taken when installing the drain hose for the indoor unit to ensure that any condensate water is
correctly drained outside.
The drain hose can be installed to the right of the base pan.
1
Installing the drain hose should be the shorter, the better.
In order to discharge condensation water, the drain hose should keep tilted.
Fix the drain hose with Cable-Tie, so that it will not separate from the machine.
2
Insulate and x the drain hose according to the gure.
Insert the drain hose to bottom of the outfall of water basin.
Lock exible hose clamp of the drain hose according to the gure.
Wind and wrap exible hose clamp and drain hose fully with thermal insulation sponge; x both ends of external layer
with ribbon for thermal insulation.
After being installed, drain hose must be insulated fully by heat insulating material. (To be provided at site.)
Flexible hose clamp
of drain hose
Joint of drain hose
Drain hose
Drain hose
Fix with Cable-Tie
Wrap thermal sleeve hose
Indoor unit
• As shown in the gure,
tighten the exible hose
clamp of the drain hose.
• After tightening the
exible hose clamp,
attach the Insulation.
Insulation
wall
hose
×
No grade
×
No slack
×
No in the water
water
After installing the pipes, close the piping
connection hole to prevent inow of dust.
(Use the insulation included with the unit, or
purchase materials that suit your site.)
To Next Page
Loading...
