Disassembly and Reassembly
3-64 Samsung Electronics
No Parts Procedure Remark
4
Heat Exchanger
1) Loosen 2 fixing earth screws(CCW) of right
side. (Use +Screw Driver.)
2)
D
etach the Connection Pipe.
3) Detach the Holder Pipe at the rear side.
4) Loosen the 4 fixing screws(CCW) of right
and left side. (Use +Screw Driver.)
5) Lifting the Heat Exchanger up a little to
push the up side for separation from the
indoor unit.
First, check Comp. Down and then
disconnect the connection pipes before
you disassemble the Evaporator from
indoor unit.
5
Fan Motor
&
Cross Fan
1) Loosen the fixing screw(CCW).
(Use +Screw Driver.)
2) Detach the Fan Motor from the Fan.
3) Detach the Fan From the left Holder
Bearing.
To Next Page
Loading...
