Samsung Electronics 46
Disassembly and Reassembly
No. Work Procedure Remark
4
1) Removing the left compressor.
- Remove the cover of the power terminal block for
the compressor.
- Use a screwdriver to pull the upper part of the cover
towards you and remove the cover, as shown in the
image.
- Unfasten the three screws on the power cables connected
to the compressor and then disconnect the power cables.
ఐ When reassembling it after inspection, be sure to tightly
fasten the screws.
∙ Check the cable connection for the U, V and W phases.
∙ A loosely fastened screw may cause a fire.
Exercise caution.
ఐ Terminal fastened with a torque 0f 25 ~ 35 kgf·m. C124
- Separate the velcro on the soundproofing felt covering
the compressor and remove the felt from the compressor.
- Remove the thermistor on top of the compressor.
Soundproofing felt
Thermistor
3-2 Disassembly and Reassembly (cont.)
3-2-4 Removal Instructions for Compressor
To Next Page
Loading...
