Samsung Electronics 108
Disassembly and Reassembly
No. Work Procedure Remark
6 1) Removing the right compressor.
- Remove the cover of the power terminal
block for the compressor.
- Use a screwdriver to pull the upper part of the cover
towards you and remove the cover, as shown in the
image.
- Unfasten the three screws on the power
cables connected to the compressor and then
disconnect the power cables.
※ When reassembling it after inspection, be sure
to tightly fasten the screws.
∙ Check the cable connection for the U, V and W phases.
∙ A loosely fastened screw may cause a fire.
Exercise caution.
※ Terminal fastened with a torque 0f 25 ~ 35 kgf·m.
VU
W
3-2 Disassembly and Reassembly (cont.)
3-2-6 Removal Instructions for Compressor
To Next Page
Loading...