To Next PageTo Next PageWhat to do if the Timer LED is on but the Samsung Air Conditioner won't turn on?
If the timer LED is lit, it means the timer is active, and the unit is in ready mode. To resolve this, cancel the timer operation. The unit should then operate normally.
Why isn't the compressor operating in COOL mode on my Samsung AM27B1C13 Air Conditioner?
The compressor will not operate in COOL mode if the room temperature is higher than the set temperature. Also, it happens after a 3-minute delay when the compressor is reoperated.
Why does the compressor stop intermittently in COOL or DRY mode on my Samsung Air Conditioner, and why does the fan speed decrease?
The compressor might stop intermittently, or the indoor unit's fan speed may decrease to prevent the air inside or outside from freezing, depending on the inside and outside air temperatures.
Why is the STD operation LED blinking on my Samsung AM27B1C13 when I plug it in?
The STD operation indication LED blinking when you first plug in your Samsung Air Conditioner indicates that power is on. This blinking will stop once you press the operation ON/OFF button on the remote control.
Why does the compressor stop intermittently in DRY mode on my Samsung AM27B1C13 Air Conditioner?
The compressor operation is automatically controlled in DRY mode depending on the room temperature and humidity.
What happens if the indoor fan is malfunctioning (speed is below 450rpm) in Samsung Air Conditioner?
NATURE LED will blink at 1Hz.
What happens if there is an indoor unit heat exchanger temperature sensor error (open or short) in Samsung AM27B1C13?
STD and TIMER LEDs will blink at 1Hz.
What happens if there is an indoor unit room sensor error (open or short) in Samsung AM27B1C13 Air Conditioner?
TIMER LED will blink at 1Hz.
General| Model | AM27B1C13 |
|---|---|
| Refrigerant | R410A |
| Cooling Capacity | 27000 BTU/hr |
| Energy Efficiency Ratio (EER) | 10.5 BTU/W-h |
| Power Supply | 220-240V, 50Hz |
| Features | Sleep Mode |
Specifies minimum clearances for indoor and outdoor units and maximum piping lengths for 18,000 Btu/h models.
Specifies minimum clearances for indoor and outdoor units and maximum piping lengths for 26,000 Btu/h models.
Specifies minimum clearances for indoor and outdoor units and maximum piping lengths for 27,000 Btu/h models.
