37
ENGLISH
Changing a particular option
You can change each digit of set option.
Option SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
Explanation PAGE MODE
The option mode
you want to change
The tens’ digit of an
option SEG you will
change
The unit digit of an
option SEG you will
change
The changed value
Remote
Controller
Display
Indication and
Details
Indication Details Indication Details Indication Details Indication Details Indication Details Indication Details
0 D
Option
mode
1~6
Tens’ digit
of SEG
0~9
Unit digit
of SEG
0~9
The
changed
value
0~F
NOTE
• When changing a digit of an indoor unit address setting option, set the SEG3 as ‘A’.
• When changing a digit of indoor unit installation option, set the SEG3 as ‘2’.
Ex) When setting the ‘buzzer control’ into disuse status.
Option SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
Explanation PAGE MODE
The option mode
you want to
change
The tens’ digit of
an option SEG
you will change
The unit digit of
an option SEG
you will change
The changed
value
Indication 0 D 2 1 7 1
• If you are using heat pump model, mixed operation mode (two or more indoor units operating in
dierent operation mode simultaneously) is not available when the indoor units are connected to
same outdoor unit. If you set the master indoor unit with a remote controller, outdoor unit will operate
in the mode which was set in the master indoor unit.
CAUTION
NASA_Big Duct_AM@@@FNHDEH@_IM_03864A-05_EN.indd 37 2016-04-01 오후 5:29:51
To Next Page
Loading...
