To Next PageTo Next PageHow to understand STD operation indication LED behavior on a Samsung AQ30C2BC Air Conditioner?
The blinking STD operation LED indicates that the power is on. To stop the LED from blinking, press the operation ON/OFF button on the remote control.
Why does my Samsung AQ30C2BC compressor stop intermittently in COOL or DRY mode and the fan speed decreases?
The compressor in your Samsung Air Conditioner may stop intermittently, or the fan speed of the indoor unit may decrease in COOL or DRY mode to prevent inside/outside air from freezing, depending on the inside/outside air temperature.
Why does my Samsung Air Conditioner compressor and indoor fan stop intermittently in HEAT mode?
In HEAT mode, the compressor and indoor fan may stop intermittently if the room temperature exceeds the set temperature. This is to protect the compressor from overheated air.
Why do the indoor and outdoor fan stop intermittently in HEAT mode on my Samsung AQ30C2BC?
In HEAT mode, the indoor and outdoor fans may stop intermittently (for within 20% of the total heater operation) because the compressor operates in a reverse cycle to remove exterior ice.
What to do if only the timer LED lights up and the Samsung Air Conditioner does not operate?
If only the timer LED is lit and the Samsung Air Conditioner isn't operating, the timer is likely activated and the unit is in ready mode. Cancel the timer operation to make the unit operate normally.
Why does the compressor stop intermittently in DRY mode on my Samsung AQ30C2BC Air Conditioner?
In DRY mode, the compressor operation is automatically controlled depending on the room temperature and humidity. This is why the compressor stops intermittently.
Why is fan speed setting not allowed in AUTO or DRY mode on my Samsung AQ30C2BC Air Conditioner?
Fan speed setting is not allowed in AUTO or DRY mode because the speed of the indoor fan is set to LL in DRY mode, and fan speed (5 steps) is selected automatically in AUTO mode.
What to do if the STD operation indication LED blinks on my Samsung AQ30C2BC?
If the STD operation indication LED blinks when you plug in the power plug of the indoor unit for the first time, it indicates that power is on. The LED stops blinking when you push the operation ON/OFF button on the remote control unit.
What to do if the indoor and outdoor units of my Samsung Air Conditioner do not operate properly?
If the indoor and outdoor units of your Samsung Air Conditioner are not operating properly, check the terminals to ensure they are correctly linked using the same number of cables.
Why does my Samsung AQ30C2BC Air Conditioner's timer LED light up but the unit doesn't operate?
The timer is likely activated, placing the unit in ready mode. To resolve this, cancel the timer operation. After canceling, the unit should operate normally.
General| Brand | Samsung |
|---|---|
| Model | AQ30C2BC |
| Category | Air Conditioner |
| Language | English |
Procedure for refilling refrigerant after leaks or installation.
Procedure for recovering refrigerant when relocating or replacing evaporator.
Steps for disassembling the indoor unit components like the front grille.
Steps for disassembling the outdoor unit components like covers and control box.
Initial checks for common air conditioner operational issues and symptoms.
Diagnosing faults by symptom, covering various operational issues and error codes.
Procedure for replacing the main PCB module.
Exploded view and parts list for the indoor unit of the air conditioner.
Exploded view and parts list for the outdoor unit of the air conditioner.
Exploded view and parts list for the indoor unit's PCB box.
Schematic diagram of the main PCB for the indoor unit.
Wiring diagram for the indoor unit of the air conditioner.
Wiring diagram for the outdoor unit of the air conditioner.
