Samsung AR09TXHQASINEU - Page 47

46
Remote Manual
Operation of buttons
1
2
4
3
8
9
7
5
10
12
11
14
RG57B1/BGE
g
UP Button ( )
Push this button to increase the indoor
temperature setting in 1ºC increments to
30ºC.
DOWN Button ( )
Push this button to decrease the indoor
temperature setting in 1ºC increments to
17ºC.
NOTE:
Temperature contol is not available
in Fan mode.
h
ECO Button
Used to enter the energy efcient mode.
Under cooling mode, press this button, the
remote controller will adjust the temperature
automatically to 24ºC, fan speed of Auto to
save energy (but only if the set temperature
is less than 24ºC). If the set temperature
is between 24ºC and 30ºC, press the ECO
button, the fan speed will change to Auto,
the set temperature will remain unchanged.
NOTE:
● Pressing the TURBO and SLEEP button,
modifying the mode or adjusting the set
temperature to less than 24ºC will stop ECO
operation.
● Under ECO operation, the set temperature
should be 24ºC or more. it may result in
insufcient cooling. If you feel uncomfortable,
just press the ECO button again to stop it.
i
TIMER ON Button
Press this button to initiate the auto-on time
sequence. Each press will increase the auto-
timed setting in 30 minutes increments. When
the setting time displays 10.0, each press will
increase the autotimed setting 60 minutes
increments. To cancel the auto-timed program,
simply adjust the auto-on time to 0.0.
j
TIMER OFF Button
Press this button to initiate the auto-off time
sequence. Each press will increase the auto
-timed setting in 30 minutes increments. When
the setting time displays 10.0, each press will
increase the auto-timed setting 60 minutes
increments. To cancel the autotimed program,
simply adjust the auto-off time to 0.0