49
Remote Manual
How to use the buttons
4
1
3
2
3
1
2
Auto operation
Ensure the unit is plugged in and power is
available.
1. Press the
MODE
button to select Auto.
2. Press the
UP/DOWN
button to set the
desired temperature. The temperature can
be set within a range of 17ºC~30ºC in 1ºC
increments.
3. Press the
ON/OFF
button to start the air
conditioner.
NOTE
1. In the Auto mode, the air conditioner can
logically choose the mode of Cooling, Fan,
and Heating by sensing the difference
between the actual ambient room
temperature and the setting temperature on
the remote controller.
2. In the Auto mode, you can not switch the
fan speed. It has already been automatically
controlled.
3. If the Auto mode is not comfortable for you,
the desired mode can be selected manually.
Cooling /Heating/Fan operation
Ensure the unit is plugged in and power is
available.
1. Press the
MODE
button to select COOL,
HEAT (cooling & heating models only) or
FAN mode.
2. Press the
UP/DOWN
buttons to set the
desired temperature. The temperature can
be set within a range of 17ºC~30ºC in 1ºC
increments.
3. Press the
FAN
button to select the fan
speed in four steps- Auto, Low, Med,or High.
4. Press the
ON/OFF
button to start the air
conditioner.
NOTE
In the FAN mode, the setting temperature
is not displayed in the remote controller
and you are not able to control the room
temperature either. In this case, only step 1,
3 and 4 may be performed.
To Next Page
Loading...
