88
SAMSUNG ELECTRONICS
9-2-16 When the remote control is not receiving
1. Checklist :
1) Check if the connector was normally assembled.
2) Check the battery in remote control
3) All the lights out and check again : Change electronic typed to a uorescent light
4) Put the set in operation and check the voltage of display PBA
5) Replace the display PBA
2. Troubleshooting procedure
Have the battery in remote control?
YES
YES
If the connector was normally assemble?
Check the connector to normally assemble.
NO
NO
Insert the battery in remote control.
All the lights out ?
NO
YES
Re-check the connector
NO
Exchange the display PBA
To Next Page
Loading...