Samsung AR36BSHUMGMX - Page 11

11
English
Installation Procedure
Main power terminal block specifications
• 1-phase
[Unit : inch(mm)]
AC power :
M4 screw
1(L)
L
F1
0.59(15)
0.40(10.1)
Communication :
M4 screw
2(N) N
F2
0.47(12)
0.45(11.4)
Main power cable specifications
The power cable is not supplied with air conditioner.
• Select the power supply cable in accordance with
relevant local and national regulations.
• Wire size must comply with the applicable local and
national code.
• Specifications for local wiring power cord and branch
wiring are in compliance with local cord.
Model
Power Source
RLA
(A)
Outdoor Indoor
MCA
(A)
MOP
(A)
Outdoor Indoor
MOC
Rated input
current of
the power
conversion
equipment
FAN1(A) FAN2(A) FAN(A)
AR36BSHUMGMX
AR36BSHUMGMN 208~230V/60Hz 14.7 1.25 1.25 0.51 21.4 35.0
NOTE
• RLA is based on AHRI 210/240 cooling standard
condition [Indoor temp. : 26.7 °C / 80 °F(DB) / 19.46°C /
67°F(WB), Outdoor temp. : 35 °C / 95 °F(DB)]
• Voltage tolerance is ± 10%.
• Maximum allowable voltage between phases is 2%.
• Symbols
– RLA: Rated Load Ampere (A)
– MOC: Maximum Operating Current (A)
– MCA: Minimum Circuit Ampere (A)
– MOP: Maximum Overcurrent Protective Device (A)
• Voltage range
– Units are suitable for use on electrical systems
where voltage supplied to unit terminal is not
below or above listed range limits.
• Maximum allowable voltage variation between phases
is 2%.
• Wire size & type must comply with the applicable local
and national code.
– Wire size: Based on the value of MCA.
– Wire type:
1-phase: 60245 IEC57(IEC) or H05RN-F(CENELEC)
grade or more
Connecting the outdoor-to-indoor power cable
and the communication cable
Indoor Unit
1(L)
1(L)
2(N)
2(N)
F1
L
F2
N
Outdoor Unit
Outdoor to indoor power cable
Main power cable
Communication cable
Cable tie
Cable clamp
DB68-11579A-00_IM_RAC oudoor_AA_EN_.indd 11DB68-11579A-00_IM_RAC oudoor_AA_EN_.indd 11 2022-01-12 오후 1:37:502022-01-12 오후 1:37:50