17
The Auto Defrost feature enables you to defrost meat, poultry or
fish. The defrost time and power level are set automatically. You
simply select the programme and the weight.
☛ Use only recipients that are microwave-safe.
1 Open the door.
Place the frozen food in the center of the glass plate. Close the door.
2 Press the Auftau-Automatik( ) button.
Result: The following indications are displayed:
(Auto Defrost mode)
(code number)
0.0 (weight)
3 Press the Auftau-Automatik ( ) button one or more times according to
the type of food to be defrosted. Refer to the table on the following page
for further details.
4 Select the food weight by turning the dial knob.
5 Increase or decrease the defrost time, if necessary, by pressing the
Plus/Minus ( ) buttons respectively.
6 Press Start ( 1min+) button.
Result: ◆ Defrosting begins.
◆ The oven beeps half way through defrosting to remind
you to turn the food over.
7 Press Start ( 1min+) again to finish defrosting.
Result: ◆ When the cooking time is over, the oven will be oven
beeping and flashing “:0” four times. And the oven will
beeps every one minute.
◆ If the door is open, or the Stop ( ) button is pressed,
current time will be displayed.
➢ You can also defrost food manually. To do so, select the
microwave cooking/reheating function with a power level
of 30%. Refer to the section entitled “Cooking/Reheating”
on page 12 for further details.
Using the Auto Defrost Feature
GB
Using a Crusty Plate
(continued)
How to clean the crusty plate
The best way to clean the crusty plate is to wash it with hot water
and detergent and rinse off with clean water. Do not use a scrubbing
brush or a hard sponge otherwise the top layer will be demaged.
➢ As the crusty plate has a Teflon layer, if you use it
incorrectly, it can be damaged.
◆
Never cut the food on the plate. Remove the food from
the plate prior to cutting.
◆
Turn the food over preferably with a plastic or wooden
spatula.
1 CE325KF total 5/14/99 3:05 PM Page 17
To Next Page
Loading...
