Disassembly & Reassembly
3-2 Samsung Electronics
3-1-2 Disassembling the CRT and Chassis
Part Name Description Description Photo
Chassis
Holder
①
Separate the Ass’y Holder chassis from
the Front Cabinet.
②
Pull the Holder Chassis while pushing
the catch up.
If you pull it with excessive power, it may
cause damage to the catch or connector.
Therefore, pull it until the catch is out of
the hole.
Pull the chassis while pushing the
clip fixing the Front Cabinet and
the Holder Chassis.
①
Separate the CRT connection, the TBC
wire,and the the speaker connection.
Since there is a hinge fixing the Wire
Connector and Connector Header, if
the wire is pulled with excessive power,
it may damage the catch or connector.
Therefore, pull it only after pressing the
hinge down completely.
Pull the chassis while pushing the
clip fixing the Front Cabinet and
the Holder Chassis.
①
Separate the D-Coil, DY-Cable and
power cord from the Front Cabinet and
Main Board.
②
Separate the power cord, DY-Cable by
pushing the fixing catch to the side and
pulling the wire up.
Pull the chassis while pushing the
clip fixing the Front Cabinet and
the Holder Chassis.
①
Separate the CRT Ass’y from the CRT.
②
Separate the TBC wire, GND cables
from the CRT Ass’y sequentially.
Pull the chassis while pushing the
clip fixing the Front Cabinet and
the Holder Chassis.
To Next Page
Loading...
