2. Adjusting the Picture Straight Lines
1. Display the Cross Hatch pattern.
2. Adjust settings other than V-AMP, V-SHIFT, H-EW and H-SHIFT so that straight lines are displayed without curves.
7. Whentheadjustmentsarecomplete,displaytheLionpatternandcheckthatthepicturesizehasnotbeenchanged.Ifthereisno
change, finish the adjustments.
3. Adjust BOW and the Angle settings so that the center line
becomes a straight line.
5. Adjust the Upper Corner and the Low Corner settings so
thatthe end of the lines become straight.
4. Adjust the H-Parabola and H-Trapezium settings so thatthe
left and right lines become straight.
6. Adjust the V-Linearity and V-SC settings so that the intervals
of the horizontal lines become uniform.