Alignment & Troubleshooting
Service Manual
4-6
Samsung Electronics
In the tray 1
1. Open and close the front cover. The jammed
paper is automatically ejected from the machine.
If the paper does not exit, go to the next step.
2. Pull the tray 1 out of the machine.
3. Remove the jammed paper by gently pulling it
straight out.
If the paper does not move when you pull, or if
you do not see the paper in this area, check the
paper exit area.
4. Insert the tray 1 into the machine until it snaps
into place. Printing automatically resumes.
In the fuser unit area
If paper is jammed in the fuser unit area, follow the
next steps to release the jammed paper.
1. Open the scan unit.
2. Open the inner cover.
To Next Page
Loading...
