● Code
02-001
02-006
● Error message
Fuser Error :#02-001 Please turn off then on.
Fuser Error :#02-006 Please turn off then on.
● Symptom
At Warm-up, this error has occurred. The machine does not work until power off/on. If the error code reoccurs,
follow the “Troubleshooting method” below.
● Possible Cause
Fuser Unit is not installed and AC is not supplied to the Heat Lamp.
● Troubleshooting method
1. Turn off the power. And turn on the power.
2. Check the connection of the Fuser AC on FDB ②.
3. Check the Fuser control harness ①.
4. Check the resistance value of the thermostat. If the value is innite, replace the thermostat.
5. If the problem persists, replace the Fuser unit.
6. Replace the SMPS board or FDB (Fuser drive board).
To Next Page
Loading...
