Inside the machine
1. Open the scan unit.
2. Open the inner cover using the handle.
3. Open the inner cover using the handle and
carefully remove the paper.
4. Pull up the paper jam levers to loosen the
tension on the rollers in the fuser unit, then
carefully remove the jammed paper out of the
area.
Note: Please be careful when working in this area
as the Fuser is hot.
5. Press down the paper jam lever to reapply
tension back to the fuser rollers in the fuser unit.
6. Close the inner cover.
7. Lower the scan unit gently and slowly until it is
completely closed. Make sure that it is securely
latched.
Be careful not to pinch your ngers!
To Next Page
Loading...
