Samsung CM1929 - Replacement of Fan Motor; Replacement of Tray; Replacement of Lamp

13
4. Disassembly and Reassembly
4-7 Replacement of Fan Motor
1. Remove the outer panel and back-cover.
2. Discharge the high voltage capacitor.
3. Remove all the lead wires from Magnetron and
High Voltage Capacitor.
4. Remove 2 screws securing the duct fan.
5. Remove 2 screws securing the Supporter-Fan
Mount.
6. Lift the Fan Motor Ass’y slightly left and pull it out.
7. Remove lead wires and connectors.
8. Turn the fan motor Ass’y over so that the bracket
side is up.
9. Remove 2 screws securing the Fan Motor.
Supporter-Fan-Mount
Duct-Fan
Ventilation Motor
C-Film
4-8 Replacement of Tray
1. Open the door.
2. Remove the tray by inserting a thin metal tool
into the gap between the oven wall and the tray
siliconcover.
3. Insert the new tray by tilting it across the oven
cavity.
4. Firstly x the front part (refers to the place where
the silicon cover is thinner than the other 3 edges)
and then place the backward part carefully and
rmly.
NOTE: Be careful when you handle the tray since it is
fragile.
Tray
4-9 Replacement of Lamp
NOTE: You don’t need to remove the outer panel or
other parts in order to replace a lamp.
1. Remove a screw securing the lamp cover.
2. Remove the lamp by rotating it clockwise.
3. Replace with a new lamp by rotating it counter-
clockwise.
NOTE : If it is necessary to replace the lamp holder,
you can disconnect lead wires by pushing
down on the hole of lead wires using a long
pointed tool.
Lamp Holder
Lamp Cover
Outer Panel