English - 34English - 34
What should I do if, after the cooking zones have been switched
o, residual warmth is not indicated in the display?
Check for the following possibility:
• The cooking zone was only briefly used and therefore did
not become hot enough. If the cooking zone is hot, please
call the customer service centre.
What should I do if the cooking zone will not switch on or o?
This could be due to one of the following possibilities:
• The control panel is partially covered by a damp cloth or
liquid.
• The child safety lock is on.
What should I do if the display is illuminated?
Check for the following:
• The control panel is partially covered by a damp cloth or
liquid. To reset, press the “On/O” control sensor.
What does it mean when the burner does not glow red?
• The selected temperature of the cooking zone is
maintained by a sensor that cycles the zone on and o,
so the surface cooking area will not always glow red. If
you select a low heat setting, the heat will cycle on and
o more frequently than at higher settings. The heat also
cycles on and o at the highest setting.
What should I do if the display is illuminated?
Check for the following:
• The hob is overheated because of abnormal operation.
• After hob is cooled down, press the “On/O” control
sensor for resetting.
If you request a service call because of an error made in
operating the appliance, the visit from the customer service
technician may incur a charge even during the warranty
period.
CTR264KC01_XFA DG68-00446A-02_EN.indd 34 2016-09-02 �� 1:29:07
To Next Page
Loading...
