15
Parts
Control Panel
Speaker
Remote sensor & Panel Key
DCH
DCH
Spacer logo
Remote sensor
―
The colour and shape of parts may differ from what is shown. Specifications are subject to change without notice
to improve quality.
Power on
Press and hold for three seconds.
Power off
Press the panel key. A popup menu appears.
Make sure Power off is selected and then, press and hold the panel key until the
display turns off.
Select source
Press the panel key. A popup menu appears.
Press the panel key again to select Source. Then, press and hold the panel key to cycle
through the desired source.
Spacer logo (optional)
Do not pull on the spacer logo using force. The logo may tear or break off.
Remote sensor
Press a button on the remote control pointing at the remote sensor on the product to
perform the corresponding function.
―
Using other display devices in the same space as the remote control of this product
can cause the other display devices to be inadvertently controlled.
Use the remote control within 7 m to 10 m from the sensor on the product at an angle
of 30° from the left and right.
The product’s screen also works as a remote sensor.
When pointing the remote control at the screen, make sure:
• the remote control is pointing towards the center of the screen.
• to use the remote control 40 cm to 70 cm away from the screen.
―
Store used batteries out of reach of children and recycle.
―
Do not use a new and used battery together. Replace both batteries at the same
time.
―
Remove batteries when the remote control is not to be used for an extended period
of time.
• To use the panel key, make sure the sliding panel key is not protruding from the bottom of the product.
• To use remote/eco sensor, make sure the sliding panel key is protruding from the bottom of the product.
To Next Page
Loading...
