Samsung Digimax 101 - Focus Adjustment; Bad Pixel Adjustment; Awb Adjustment; Trig Adjustment

23
11.. RReeppllaacceemmeenntt PPaarrttss aanndd AAddjjuussttmmeenntt IItteemmss
Digimax 101 requires electrical adjustments when certain parts are replaced.
The table below indicates the adjustments required for the respective part replacements.
22.. AAddjjuussttmmeenntt TToooollss
The following tools are required for electrical adjustment.
▶ Program
Please contact to our website (www.ssa.net) and download the each programs.
- Firmware : Latest version
- Bad pixel adjustment : SDC1071 and SUNAP0916
▶ Equipment
- Light source
- AE Tester : Adjust at LV 7.0 and check the flash on at LV 6.8, or flash off at LV 7.2.
- Others :
Osilloscope, TV monitor
▶ Chart
- Focus chart : Please contact to our website (www.ssa.net) and print the focus Chart on the
paper from the “101CHART.pdf ”
- Gray chart : Standard 31% Gray Chart.
Main board Strobo board Switch board Lens module TFT LCD
Update Firmware ○
AWB adjustment ○
Focus adjustment ○ ○
Bad pixel adjust. ○
Trig adjustment ○ ○
Strobo adjustment ○ ○
LCD adjustment ○ ○
Burnin check ○ ○ ○ ○ ○
ⅣⅣ.. AADDJJUUSSTTMMEENNTT
Program Equipment Chart
Update Firmware Firmware
AWB adjustment Light source
5100。K
Focus adjustment TV Monitor Focus chart
Bad pixel adjust. SDC1071 Light source
5100。K
Trig adjustment AE Tester
LV 6.8/7.0/7.2
Strobo adjustment Gray reflector
LCD adjustment Osilloscope
Burnin check