29
5) TFT LCD adjustment
a. Disassemble Front cover and Rear cover of camera.
b. Turn on the power of camera. (recommended to use Adapter)
c. Connect a oscilloscope like below picture.
d. Connect a GND to GND of TFT LCD and make Check to be positioned left side of R26.
[Fig. no. 1]
e. At this time, adjust the output signal by +3.9V, -1.7V..
[Fig. no. 2] [Fig. no. 3]
f. When finishing an adjustment, assemble a Cover.
ⅣⅣ.. AADDJJUUSSTT MMEENNTT
To Next Page
Loading...
