Samsung DIGIMAX A302 - LCD Button

《32》
+/- button
■ Exposure compensation
: This camera automatically adjusts the exposure according to the ambient lighting
conditions. You can also select the exposure value by using the +/- button.
● Compensating Exposure
1. Press the +/- button, and then use the UP and DOWN
buttons to select the exposure compensation icon ( ).
The exposure compensation menu bar will appear as
shown.
2. Use the LEFT and RIGHT buttons to set the desired
exposure compensation factor.
3. Press the +/- button again. The value you set will be
saved and the Exposure Compensation setup mode will close. If you change the exposure
value, the exposure indicator ( ) will be displayed on the bottom of the LCD monitor.
* A negative exposure compensation value reduces the exposure.
Note that a positive exposure compensation value increases the exposure and the LCD
monitor will appear white or you may not get good pictures.
[ Image & full information ]
[ Image & basic information ]
[ LCD off ]
■ You can check the recording status in the LCD monitor.
Pressing the LCD button in the RECORDING (STILL
IMAGE, MOVIE CLIP) mode will change the display as
shown below.
■ If the LCD monitor is turned off, the camera status lamp will light up.
Pressing the
LCD button
Pressing the
LCD button
Pressing the LCD button
LCD button