Samsung DIGIMAX A302 - Beep; Frequency

《74》
Beep
■ If you set the operation sound to ON, various sounds will be activated for camera startup,
when button are pressed, and if there is a card error, so that you can be aware of the camera
operation status.
■ The alternating current frequency influences the image quality.
If you don't select the same [FREQUENCY] sub menu as your nation's alternating current
frequency, there will be a line on a stored image. Should this be the case, change the
[FREQUENCY] sub menu.
● Setting Operation Sounds
1. In any mode with the exception of Voice Recording mode,
press the MENU button.
2. Press the LEFT/ RIGHT button and select the [SETUP]
menu tab.
3. Select the [BEEP] menu by pressing the UP/ DOWN
button and press the RIGHT button.
4. Select a desired sub menu by pressing the UP/ DOWN
button and press the OK button.
[BEEP] sub menu : OFF/ ON
5. Press the menu button twice and the menu will disappear.
● Selecting frequency type
1. Press the MENU button.
2. Press the LEFT/ RIGHT button and select the [SETUP]
menu tab.
3. Select the [FREQUENCY] menu by pressing the
UP/ DOWN button and press the RIGHT button.
4. Select a desired sub menu by pressing the UP/ DOWN
button and press the OK button.
- [FREQUENCY] sub menu : 50Hz, 60Hz
5. Press the menu button twice and the menu will disappear.
● 60Hz : U.S.A, Canada, Japan, South Korea, Taiwan, Mexico.
● 50Hz : Australia, Austria, Belgium, China, Denmark, Finland, Germany, U.K., Holland,
Italy, Kuwait, Malaysia, New Zealand, Singapore, Spain, Sweden, Switzerland,
Thailand, Norway.
2048
◀▶
SETUP
DATE TYPE
IMPRINT
BEEP
OFF
ON
BACK:
◀
SET:OK
2048
◀▶
SETUP
IMPRINT
BEEP
FREQUENCY
50Hz
60Hz
BACK:
◀
SET:OK
Frequency