《15》
Starting the recording mode
■ How to use the M (Manual) mode ( )
You can manually configure all functions with the
aperture value and shutter speed.
1. Select the M mode by rotating the mode dial.
2. Press the ASM button and the aperture value or
the shutter speed will turn to red.
Up/ Down button : changes the aperture value.
Left/ Right button : changes the shutter speed.
3. Press the ASM button and the M (Manual) mode
or the shutter priority mode will be selected.
Press the shutter button to capture an image.
[M mode]
● Smaller Aperture values make the object sharp but blur the background.
Larger Aperture values make both the object and background sharp.
● High Shutter speeds can capture a moving object in a still image as if the
object is not moving. Low Shutter speeds can capture a moving object with
an ‘active’ effect.
INFORMATION
■ How to use the Wide angle mode ( )
You can select the wide angle mode or normal
angle mode by using this button
1. Select the Wide angle mode by rotating the
mode dial.
2. Press the Wide button and the screen size will
be changed as shown.
3. Point the camera towards the subject and
compose the image by using the LCD monitor.
4. Press the shutter button to capture an image.
※ When you select the wide angle mode, sub menus of the [SIZE] menu are
changed. For details of the sub menu changes, refer to the table below.
Size 5M 4M 3M 2M 1M
Wide angle mode
3264X1632 2816X1408 2272X1136 2048X1024 1600X800
[Wide angle mode]
To Next Page
Loading...
