《23》
Flash ( )/ Left button
● If you press the shutter button after selecting the Auto, Fill-in, Slow sychro
flash, the first flash fires to check the shooting condition (Flash range and
Power ratio of flash).
Do not move the camera until the second flash fires.
● Using the flash frequently will reduce the life of the battery.
● Under normal operating conditions the charging time for the flash is
normally within 5 seconds. If the battery is weak, the charging time will be
longer.
● During the continuous shot, AEB, Motion capture mode and movie clip
mode, the flash function will not operate.
● Take photographs within the flash range.
● The image quality is not guaranteed if the subject is too close or highly
reflective.
● When taking an image in poorly lit conditions with the flash, there may be a
white speck in the captured image. The speck is caused by the reflecting of
the flash light from the atmospheric dust. It is not camera malfuction.
INFORMATION
● Flash range
(Unit : m)
■ When the menu is displayed on the LCD monitor,
pressing the LEFT button makes the cursor shift to
the left tab.
■ When the menu is not displayed on the LCD monitor,
the LEFT button operates as the FLASH
( ) button.
● Selecting the flash mode
1. Rotate the MODE DIAL to select a RECORDING mode with the exception of
Movie clip and Motion capture modes.
2. Press the Flash button until the desired flash mode indicator displays on the
LCD monitor.
3. A flash mode indicator will be displayed on the LCD monitor.
Use the correct flash to suit the environment.
Normal
WIDE TELE WIDE TELE WIDE TELE
0.8 - 3.0 0.8 - 2.5 0.2 - 0.8 0.5 - 0.8 0.2 - 3.0 0.5 - 2.5
Macro
Auto macro
ISO
AUTO
To Next Page
Loading...
