[Basic information]
■ Idle mode : If you select the [LCD Save] and the camera isn't operated during
the specified time(about 30 SEC.), the camera power will be idle (LCD monitor :
OFF, Camera status lamp : Blinking) automatically. To use the camera again,
press any of the camera buttons except the power button. If there is no
operation during the specified time, the camera power will be turned off
automatically to save battery life.
Refer to page 60 for more information about the auto power off function.
■ Histogram
Histogram shows you the distribution of brightness
in recorded images. If the bars in the histogram are
higher towards the right, the image may be too
bright. If the bars are higher on the left, the image
may be too dark. If the lighting conditions are too
bright to check the subject by using the LCD,
checking the histogram will enable more precise
exposure control for the shots.
Pixel
Dark
Bright
Distribution of brightness
■ You can adjust the sharpness of the picture you
want to take. You cannot check the sharpness effect
on the LCD monitor before you take a picture,
because this function is applied only when the
captured image is stored on the memory.
[ PROGRAM mode ]
SHARPNESS
Soft
Normal
Vivid
Sub menu Icon Description
The edges of the image are softened.
This effect is suitable for editing images on your PC.
The edges of the image are sharp.
This is suitable for printing.
The edges of the image are emphasized. The edges
will appear sharp, but noise may occur in the
recorded image.
Vivid
Normal
Soft
To Next Page
Loading...
