Samsung Digimax S500 - Page 51

52
Ⅳ.ADJUSTMENT
PUNT ADJUSTMENT PROCESS
ZOOM 0 : 127
ZOOM 1 : 123
ZOOM 2 : 117
ZOOM 3 : 117
ZOOM 4 : 123
ZOOM 5 : 129
ZOOM 6 : 120
ZOOM 7 : 117
< Figure 7-2 >
< Figure 7-1 >
7) PUNT ADJUSTMENT
After changing the MAIN PCB and BARREL, adjust the PUNT.
< Codes of program >
< How to adjust the item >
a. Arrange a chart for adjust the PUNT.
b. Attach the camera to the tripod.
c. The distance between the chart and the camera should be 80cm.
d. Insert the codes and save the program in the SD card.
e. Insert the SD card to the camera and turn on the camera.
f. After completing the adjustment, the camera will be turned off.
※ If the adjustment is incomplete, < Figure 7-2 > will display. In this case, re-try the adjustment process.
BASIC PROGRAM PUNT ADJUSTMENT
<1> PROCESS CODE ; <1>2;
<2> 65535 ; <2>65535;
<3> PROCESS CODE ; <3>2,3;
<4> 0 OR 1 ; <4>1;
<5> 0 OR 1 ; <5>1;
<6> CONDITION ; <6>1,0,1,2,3,4,5,6,7;
<7> SPEC ; <7>
7,245,51,248,43,240,41,238,47,244,49,246,38,235,63,230,13,225,25,228,29,220,36,218,44,224,53,226,51,215,67,210;
<8> NOT <8>;
<9> NOT <9>;
<10> NOT <10>;
<11> NOT <11>;
<12> NOT <12>;
<13> NOT <13>;
<14> 0 <14>65504;
<15> 0 <15>0;