21
NOTES:
1. If the Hot Keypad feature has been turned off, you must first lift the hand-
set or press the SPEAKER key before you begin dialling.
2. The saved telephone number is stored in memory until you save anoth-
er number.
3. Redial does not apply to intercom calls.
CHAIN DIALLING
You may manually dial additional digits following a speed dial number or
chain as many speed dial numbers together as required:
• After the first speed number is dialled, press SPD again and dial anoth-
er speed number OR manually dial additional digits following a speed
dial number.
AUTOMATIC REDIAL/RETRY
When you are making an outside call and you receive a busy signal, the sys-
tem can automatically redial the number for you. It will automatically redial
at a pre-programmed interval for up to 15 attempts.
• When you hear a busy signal, press the RETRY button.
• The system will reserve the line and automatically redial the same num-
ber for you. You will hear the call being made through the keyset speak-
er. The microphone is muted.
• When the called party answers, you must pick up the handset or press
the ANS/RLS or SPEAKER key before you can begin speaking. You
must answer within 10 seconds.
NOTES:
1. If you make another call, auto-redial is canceled.
2. To cancel a retry, lift and replace the handset.
PULSE TO TONE CHANGEOVER
When making an outside call on a dial pulse line, press #. All digits dialled
after the # with be sent as tones.
To Next Page
Loading...
