DS 616 INSTALLATION
TECHNICAL MANUAL PART 4 JUNE 2002
4.3
4.5 DEFAULT TRUNK AND STATION NUMBERING
Upon initial power up, the CPU reads the trunk expansion slot for the existence of a
card and identifies the type of card. It stores this as the default configuration.
The system assigns trunk numbers beginning with 701 and continues to 703 if the
3TRK card has been installed or to 706 if the 6TRK card has been installed.
Station numbers are assigned in the same manner. The lowest station is assigned
station number 201 and continues to 216.
Default data assigns the keyset in the lowest port to the operator group and all trunks
ring that station until the default is changed.
Station and trunk numbers can be changed, rearranged and reassigned, as needed
using system programming.
To Next Page
Loading...
