English
Installation
English36
Exhaust ducting guide (Not applicable to ventless (heat pump) models)
Ducting
1. Make sure the dryer is installed properly so the air exhausts freely.
2. Use 4-inch rigid metal ducts. Tape all joints including the dryer connection. Never use lint-trapping
screws.
3. To facilitate the exhaust, keep the ducts as straight as possible.
Cleaning
Clean all old ducts before installing the dryer, and make sure the vent flap opens and closes freely. We
recommend that you clean the exhaust system annually or on a regular basis.
WARNING
• To prevent fire, do not use plastic, thin-foil, or non-metal flexible ducts of any kind.
• Do not use a poor exhaust system because it slows down the dryer’s performance.
• Do not use excessively long ducts that have multiple elbows.
• Do not use crushed or clogged venting or ducts.
Door reversal
CAUTION
• Unplug the power cord before you reverse the door.
• Put a soft rug on the floor to place the door when you remove it. This will prevent the door from being
scratched.
1. Remove the door glass gasket.
DV8900HB_SimpleUX_WEB_OID57652_English.indd 36 2022-09-07 11:27:19
To Next Page
Loading...
