Why still picture has severe 'noise bars' streaks on Samsung DVD VCR Combo?
When the ?II button is pressed during playback, the still picture has severe 'noise bars' streaks on your Samsung DVD VCR Combo because a still picture may have 'noise bars', depending on the condition of the tape. Press the TRK ( or ) buttons during slow motion to minimize this effect.
How to remove noise bars or streaks on playback on Samsung DVD-V5500?
If you see noise bars or streaks on playback with your Samsung DVD VCR Combo, press the TRK ( or ) buttons to minimize this effect.
How to resolve TV interference when tuning to Samsung DVD-V5500?
If you experience interference when tuning your TV to the Samsung DVD-VCR Combo, remove the aerial input plug from the jack marked with the aerial symbol on the rear of the DVD-VCR. Follow the instructions for 'Tuning Your Television for the DVD-VCR'. Then follow the instructions for 'Setting the DVD-VCR output Channel', and move the channel number several channels down from the original setting. Replace the aerial plug into the jack marked with the aerial symbol on the rear of the DVD-VCR. Re-tune your TV to the DVD-VCR again by following instructions 'Tuning Your Television for the DVD-VCR'. If the problem persists, repeat these steps, moving several more channels away from the original setting.
What to do if timer recording is unsuccessful on Samsung DVD-V5500 DVD VCR Combo?
If timer recording was unsuccessful on your Samsung DVD VCR Combo, ensure the STANDBY/ON button was pressed to activate the timer. Re-check the recording start/stop time settings. Note that a power failure or interruption during timer recording will cancel the recording.
Why can't I see normal broadcasts on my Samsung DVD-V5500?
If you cannot see normal broadcasts on your Samsung DVD VCR Combo, check the tuner or external setting and ensure it is set to tuner. Also, check the TV or VCR aerial connections.
Why my Samsung DVD-V5500 didn't record the TV programme?
If your Samsung DVD VCR Combo didn't record a TV program, check the DVD-VCR aerial connections and make sure the tuner is properly set. Also, verify that the safety tab on the cassette is intact.
What to do if Samsung DVD-V5500 DVD VCR Combo disc does not play?
If your Samsung DVD VCR Combo disc does not play, make sure the disc is inserted with the label side facing up. Also, verify the DVD region code is compatible with your player.
Why is my Samsung DVD-V5500 remote not working?
If the remote control isn't working with your Samsung DVD VCR Combo, first check and replace the batteries if needed. Ensure you are within 20 feet of the unit. If problems persist, remove the batteries, press and hold any button(s) on the remote for a few minutes to reset its microprocessor, then reinstall the batteries and try again.
How to fix no power on Samsung DVD-V5500?
If your Samsung DVD VCR Combo has no power, verify that the power plug is securely connected to a working wall outlet.
Why Samsung DVD-V5500 DVD VCR Combo disc does not play?
If a disc isn't playing on your Samsung DVD VCR Combo, make sure the disc is inserted with the label side facing up and check the region number of the DVD to ensure it is compatible.
General| Audio formats supported | MP3, WMA |
|---|---|
| I/O ports | RF in RF out SCART Composite out Audio L/R out |
| Zoom capability | Yes |
| Digital audio coaxial out | 1 |
| Device type | DVD player |
| Product color | Silver |
| Disc types supported | DVD+RW, DVD-R, DVD-RW |
To Next Page
