21
ENG
● CONNECTIONS
How to Install the Speaker on the Stand (HT-BD1252/HT-BD1255)
1. Turn the STAND upside-down and connect it
to the STAND BASE.
2. Insert five small SCREWS into the five holes
marked with arrows using a screwdriver as
shown in the illustration.
3.
Connect upper SPEAKER to the assembled STAND.
4.
Insert another large SCREW into the hole on the
rear of the speaker marked with arrow using
a
screwdriver.
1 2
3 4
M
If you place a speaker near your TV set, screen colour may be distorted because of the magnetic field `
generated by the speaker. If this occurs, place the speaker away from your TV set.
Do not let children play with or near the speakers. They could get hurt if a speaker falls.
`
When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct. `
Keep the subwoofer speaker out of reach of children so as to prevent children from inserting their hands or `
alien substances into the duct (hole) of the subwoofer speaker.
Do not hang the subwoofer on the wall through the duct (hole).
`
Front Speaker (R)
Centre Speaker
Subwoofer Speaker
Rear Speaker (R) Rear Speaker (L)
Front Speaker (L)
HT-BD1255
Front Speaker (R)
Subwoofer Speaker
Rear Speaker (R) Rear Speaker (L)
Front Speaker (L)
HT-BD1252
Centre Speaker
Front Speaker (R)
Subwoofer Speaker
Rear Speaker (R) Rear Speaker (L)
Front Speaker (L)
HT-BD1250
Centre Speaker
STAND BASE
STAND
STAND
SPEAKER
To Next Page
Loading...
