Samsung HT-D5130 - Installing the Speakers on the Tallboy Stand; Connecting the Speakers

20 English
Connections
SPEAKERS OUT
SPEAKER IMPEDANCE : 3
NENT OUT
VIDEO OUT
SUBWOOFER SURROUND
CENTER SURROUNDFRONT
FRONT
OUT
VIDEO OUT
SPEAKERS OUT
SPEAKER IMPEDANCE : 3
SUBWOOFER SURROUND
CENTER SURROUNDFRONT
FRONT
Center Speaker
Front Speaker (R)
Subwoofer
Surround Speaker (R)
Front Speaker (L)
Installing the Speakers on the Tallboy Stand
Turn the Stand Base upside-down and connect it
to the Stand.
Insert small screws (4x20, For connecting Stand &
Stand Base) clockwise into the four holes marked
using a screwdriver as shown in the illustration.
CAUTION
When you use a torque screwdriver, be careful not
to put excessive force. Otherwise, it runs idle or
can be damaged. (torque screwdriver- below 15
kg.f.cm)
Connect the upper Speaker to the assembled
Stand.
Insert another large screw (5x15, For connecting
Speaker & Stand) clockwise into the hole on the
rear of the speaker using a screwdriver.
This is the appearance after the speaker is
installed. Follow this steps to install other speaker.
1.
2.
!

3.
4.
5.
Connecting The Speakers
Press down the terminal tab on the back of the speaker.
Insert the black wire into the black terminal (–) and the red wire into the
red terminal (+), and then release the tab.
Connect the connecting plugs to the back of the product by matching the
colors of the speaker plugs to the speaker jacks.
1.
2.
3.
Black
Red
4
2
Stand
Stand
Base
1
3
Stand
Speaker
5
Surround Speaker (L)
HT-D5130_XAC_0201.indd 20HT-D5130_XAC_0201.indd 20 2011-02-09 ¿ÀÈÄ 5:03:532011-02-09 ¿ÀÈÄ 5:03:53