Turn off your Home Theater.
Press the 4, 7, 6, 3 buttons on the remote
control in order.
The Power LED blinks once.
Connect the iPod/iPhone to the Wireless
transmitter.
Turn on the iPod/iPhone. Press the "ID SET"
button on the back of the Wireless transmitter
for 5 seconds. The link light on the wireless
transmitter blinks rapidly.
Turn on your product.
To listen to music from your iPod/iPhone over
the product, press the button to select "W.
IPOD" mode.
After you select "W. IPOD" mode, turn the
volume of the product down to avoid hearing
damage.
You can control the speaker volume of the
iPod/iPhone with a volume wheel or a volume
bar.
When the iPod/iPhone is stopped or in a power
saving mode, the Wireless transmitter enters
Sleep Mode. When iPod/iPhone is set to Deep
Sleep Mode, the Wireless transmitter turns off.
Operation status of the wireless
transmitter's LED
•
•
•
•
•
Display
Function
LINK
(Blue LED)
STANDBY
(Red LED)
LED ON
Pairing successfully
completed
STANDBY
LED BLINK
(Long blink)
Processing iPod/
iPhone
LOW
BATTERY
LED BLINK
(Short blink)
Processing pairing Pairing failed
CAUTION
If you use a wireless device such as a laptop
computer, an AP, or Wi , near the main home theater
unit, an unstable operation error can occur.
Do not pair the SWA-5000 and iPod/iPhone at the
same time. If you pair them at the same time, the
iPod/iPhone and SWA-5000 may not connect to the
product.
The maximum transmission distance from the product
to the wireless transmitter is about 16.4 feet, but may
vary depending on your operation environment.
The audio signal may be weakened or even lost where
there is an obstacle such as a wall or partition
between the product and wireless transmitter. You
can also weaken or lose signal if you move the
wireless transmitter around.
You can enjoy the feeling of a karaoke bar in the
comfort of your home.
Watch the video and sing along the lyrics displayed
on the TV screen against the accompaniment.
Connect the microphone to the MIC
jack on the front panel.
Press the ECHO button to adjust the
echo level of the microphone.
Press the MIC VOL button to adjust
the voice volume of the microphone.
NOTE
The microphone operates only in
Home menu, BD playback and DVD
playback modes.
The karaoke scoring displays the score
automatically when the Karaoke Scoring is set to
On and a microphone is connected. Disconnect the
microphone if you do not want to display the score.
!
✎
To Next Page
Loading...
