Dolby Pro Logic II Mode
You can select the desired Dolby Pro Logic II audio
mode.
Press the
PL II button.
MUSIC
When listening to music, you can
experience sound effects as if you are
listening to the actual performance.
MOVIE
Adds realism to the movie soundtrack.
PROLOG
You can listen to a 2CH sound source
in 5.1CH surround sound with all
speakers active.
- A specic speaker(s) may not be
output depending on the input signal.
MATRIX
You will hear multi-channel surround
sound.
STEREO
Select this to listen to sound from the
front left and right speakers and the
subwoofer only.
NOTE
When selecting Pro Logic II mode, connect
your external device to the AUDIO INPUT jacks
(L and R) on the product. If you connect to only
one of the inputs (L or R), you cannot listen to
surround sound.
The Pro Logic II function is only available in
Stereo mode.
The Pro Logic II function is not available while
playing AC3 signal in 2.1 channel mode.
Using buttons on the Remote Control
Press the FUNCTION button to select FM.
Tune in to the desired station.
Preset Tuning 1 : You must rst add a desired
frequency as a preset. Press the STOP (@)
button to select PRESET and then press the
✎
`
`
`
~
TUNING/CH( ) button to select the preset
station.
Manual Tuning : Press the STOP (@) button to
select MANUAL and then press the TUNING/CH
(
) button to tune in to a lower or higher
frequency.
Automatic Tuning : Press the STOP (@) button
to select MANUAL and then press and hold the
TUNING/CH(
) button to automatically
search the band.
Setting Mono/Stereo
Press the MO/ST button.
Each time the button is pressed, the
sound switches between STEREO and
MONO.
In a poor reception area, select MONO for a clear,
interference-free broadcast.
Presetting Stations
Example : Presetting FM 89.10 in the memory
Press the FUNCTION button to
select FM.
Press the
TUNING/CH ( ) button
to
select <89.10>.
Press the TUNER MEMORY button.
Number ashes on the display.
Press the
buttons
to select preset number.
You can select between 1 and 15 presets.
Press the TUNER MEMORY button again.
Press the TUNER MEMORY button before
number disappears from the display.
Number disappears from the display and the
station is stored in memory.
To preset another station, repeat steps 2 to 5.
~
~
~
~
~
~
~
~
To Next Page
Loading...
