Samsung HT-DM550 - Speaker Balance and Test Tone; Adjusting Speaker Balance Levels; Using the Test Tone Feature

33
To set up Speaker Balance
To set up Speaker Balance
LCR
LS
LFE
SRS
D I G I T A L
LCR
LS
LFE
SRS
D I G I T A L
LCR
LS
LFE
SRS
D I G I T A L
LCR
LS
LFE
SRS
D I G I T A L
LCR
LS
LFE
SRS
D I G I T A L
1
Use the Left/Right ( / ) button to make
adjustment.
•
Each time the button is pressed, the selection switches as shown below.
Example: 5.1CH Sound Setup
OFF, range of –6 ~ 0
OFF, range of –6 ~ 0
range of –6 ~ –00 ~ +6
range of –6 ~ –00 ~ +6
range of –6 ~ –00 ~ +6
Front Speakers: L level, R level
Rear Speakers: L level, R level
Center Speaker
Rear Speakers
Subwoofer Speaker
Sound Edit
Press the Sound Edit button.
▲
▲
2
The display changes depending on the current audio output
mode (DSP, PRO LOGIC, 3-STEREO, STEREO, etc.).
While in DSP or PRO LOGIC mode, TEST TONE may
operate differently for VCDs or CDs.
Speaker Setting Methods
•
The test signal will be sent to the Left Front ➞ Center ➞ Right
Front ➞ Right Rear ➞ Left Rear ➞ Subwoofer in that order.
Test Tone
Press the Test Tone button.
To End the Test Tone
Test Tone
•
Press the Test Tone button again.
L
LS
RS
C
SUB
WOOFER
R