|
32 English
Settings
❏
Wired - Manual
If you have a static IP address or the Automatic
procedure does not work, you'll need to set the
Network Settings values manually.
After following Steps 1 to 3 above:
1 . Select the Start in the Network Settings
screen, and then press the
E
button.
The Network Status screen appears.
The player attempts to verify the network
connection and fails.
Network Settings
Retry
IP Settings
Previous
OK
Wireless network disconnected
Unable to connect to wireless router. Try the following: check
that the router is turned on, and if it is, try turning it off and on
again. Check if you need to enter a security key to use the router.
MAC Address XX:XX:XX:XX:XX:XX
IP Address 0.0.0.0
Subnet Mask 0.0.0.0
Gateway 0.0.0.0
DNS Server 0.0.0.0
2 . Select IP Settings on the right of the screen,
and then press
E
button.
The IP Settings screen appears.
3 . Select the IP Mode field, and then set to
Manual.
4 . Use the number keypad on your remote to
enter the Network values. Use the
▲▼◄►
buttons on the remote to move from entry
field to entry field.
|
NOTE
|
\
You can get these values from your Internet provider. You
can also view these values on most Windows computers.
For instructions, see "Getting the Network Settings
Values." on page 33.
5 . When done, highlight OK, and then press
E
button. The player verifies the network
connection and then connects to the
network.
Networks and the Internet
When you connect this player to a network,
you can use network based applications and
functions such as Smart Hub and BD-LIVE,
and upgrade the player's software through the
network connection. For more information about
accessing and using Internet services, see the
Network Services chapter of this manual on pages
53~55. Instructions for configuring the network
connection start below.
Configuring Your Network Connection
Before you begin, contact your ISP to find out
if your IP address is static or dynamic. If it is
dynamic, and you have a wired or wireless
network, we recommend using the Automatic
configuration procedures described below.
If you are connecting to a wired network, connect
the player to your router using a LAN cable before
you start the configuration procedure.
If you are connecting to a wireless network,
disconnect any wired network connection before
you begin.
To begin configuring your network connection,
follow these steps:
1 . In the Home menu, select Settings, and then
press the
E
button.
2 . Select Network, and then press the
E
button.
3 . Select Network Settings, and then press the
E
button.
4 . Go to the instructions for Wired networks
starting below or the instructions for Wireless
networks starting on page 33.
Wired Network
❏
Wired – Automatic
After following Steps 1 to 3 above:
1 . Select the Start in the Network Settings
screen, and then press the
E
button. The
player detects the wired connection, verifies
the network connection and then connects to
the network.
To Next Page
Loading...
