Converts audio sound of the CD into a MP3 le format before sending to a USB storage device.
B
Connect the USB device.
Insert the audio CD into the CD tray.
Press the button.
To start ripping the current track, press the
button on the remote control while the system is playing a
track or stopped temporarily.
To rip the whole tracks of the CD, press and hold the
button on the remote control.
The system displays a message of "CD RIPPING" on the
display and starts ripping.
Press the (@) button to stop ripping.
When the CD ripping is done, a directory named
"RIPPING" will be created in the USB device and the
ripped le will be saved in a format of "SAM_XXXX”.mp3".
Do not disconnect the USB connection or the power cable during the CD ripping.
Otherwise, it may cause damage to the data. To stop CD ripping, press the button
and disconnect the USB device after the system stops playing the CD completely.
If you disconnect the USB connection during the CD ripping, the system will turn off and you will not
be able to delete the ripped le. In this case, connect to a PC using the USB cable, and back up the
data and format the USB device.
If you connect the USB device to the system while it is playing a CD, the system stops
playing and will resume playing when the initialization of the USB connection is completed.
(The initialization time may differ depending on the type of the USB device.)
The feature of CD RIPPING is not applied to the DTS-CD.
If the ripping duration is less than 5 seconds, a ripping le may not be created.
CD ripping is enabled only if the USB device or the HDD is formatted in the FAT le
system. (The NTFS le system is not supported.) For a list of compliant devices, refer to
the speci cation of the USB host.
The ripping is performed in a normal speed of x1 and the ripping time may be extended for
some USB devices.
While the system is ripping a CD, the audio sound will not be output.
Do not put force on the system while it is ripping a CD.
~
~
~
~
M
`
`
`
`
`
`
`
`
`
To Next Page
Loading...
