Using the Anynet+(HDMI=CEC) function
Anynet+ is a function that enables you to control other Samsung Devices
with your Samsung TV's remote control.
TheAnynet+ function turns on and off each time you press Anynet+.
1.Connect the product to a Samsung TV with an HDMI cable.
(See page 13)
2.Set the Anynet+ function on your TV and the SAT to ON. (See the
TV instruction manual for more information.)
,_Depending on your TV,certain HDMI output resolutions may not
work.
,_Please refer to the user's manual of your TV and check for the
4;;y_: logo (Ifyour TV has an 4;;_t logo, then it supports the
Anynet+ function.)
Using the TV functions (with Samsung TVs only)
• PressTV SOURCE on the remote control to change the TV's input source.
Press TV INFO on the remote control to display the TV channel
information.
Press TV CH on the remote control to select the TV channel.
Press TV VOL on the remote control to increase or decrease the volume
level.
• Use TV PRE-CH button to move to the previous TV channel in TV mode.
= To exitthe TV menu,usethe "iV EXIT button. (Itfunctionsthe same as the
EXITbutton of theTV remotecontrol.)
SOFTWARE UPGRADE
When you press the SoundShare button, the TV's sound is
transmitted through the Air Track system via a Bluetooth
connection. The Air Track also controls the sound volume,
sound quality, etc.
The remote control can operate TVs made by SAMSUNG only.
Samsung may offer upgrades for the CrystalSurround AirTrack's
system firmware in the future.
Ifan upgrade is offered, you can upgrade the firmware by connecting a
USB drive with the firmwareupgrade stored on it to the USB port on
your Air Track.
Notethat ifthere are multiple upgrade files, you must load them ontothe
USB drive singly and usethem to upgrade the firmware one at a time.
PleasevisitSamsung.com or contact the Samsung call center to receive
more information about downloading upgrades files.
22
,_,Inserta USB drivecontainingthe firmwareupgrade intothe USB porton the main unit.
,_,Do not disconnectthe power or removethe USB drive whileupgradesare being applied.The main unitwillturn
oft automaticallyafter completingthe firmwareupgrade.
Whensoftware is upgraded, settingsyou havemade willreturnto their default(factory)settings.
We recommendyou writedown your settingsso that youcan easilyresetthem afterthe upgrade.
,_,Once upgradingthe product software iscompleted,turn oftthe product and then pressand hold (=) button for
a whileto resetthe product.
,_,Ifthe firmwarefailsto upgrade, we recommendformatting the USBdevice in FAT16and trying again.
,_,Forupgrading purposes,do not format the USB drive in NTFSformat because itis not a supported file system.
,_,Dependingonthe manufacturer,some USBdevicesmay not be supported.
To Next Page
Loading...
