English-16
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna) and “cable” channels. After the available chan-
nels are memorized, use the CH or CH buttons to scan through the channels. This eliminates the need to change channels by entering
the channel digits. There are three steps for memorizing channels: selecting a broadcast source, memorizing the channels (automatic) and
adding and deleting channels (manual).
Selecting the Video Signal-sour
ce
Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the
TV (i.e. an antenna or a cable system).
1. Press the MENU button to display the menu.
Press the or buttons to select “Channel”, then press the
ENTER button.
2. Press the ENTER button. Repeatedly press the or buttons to cycle
through these choices: “Air”, “STD”, “HRC”, or “IRC” (all cable TV).
Press the
EXIT button to exit.
STD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable system that exists in
your particular area.
At this point, the signal source has been selected. Proceed to “Storing Channels
Automatically”.
Storing Channels in Memory (Automatic Method)
1. First, select the correct signal source (Air, STD, HRC, or IRC).
2. Press the or buttons to select “Auto Program”, then press the ENTER button.
3. Press the ENTER button to select “Start”.
The TV will begin memorizing all of the available channels.
The TV automatically cycles through all of the available channels and stores them in
memory. This takes about one to two minutes. Press the
ENTER
button at any time to
interrupt the memorization process and return to the “Channel” menu.
4. After all the available channels are stored, the
“Channel” menu reappears. Press the EXIT button to exit.
To stop the search before it has finished, press the
ENTER
button with “Stop” selected.
BN68-01001W-00Eng.qxd 7/24/06 8:04 PM Page 16
To Next Page
Loading...
