English-22
Selecting a Signal Source (External A/V) for PIP.
3. Press the or buttons to select “Source”, then press the ENTER button.
Select the source of the sub picture (PIP) by pressing the or buttons and
press the ENTER button.
The sub picture can serve different source selections based on what the main picture is set to.
Swapping the Contents of the PIP and Main image
4. Press the or buttons to select “Swap”, then press the ENTER button.
SWAP is available in HDMI mode only.
Changing the PIP Channel
5. Press the or buttons to select “Channel”, then press the ENTER button.
Press the or buttons to select the desired channel in the PIP window.
Press the
ENTER buttons.
The channel can be active when the sub picture is set to TV.
Changing the Position of the PIP Window
6. Press the or buttons to select “Position”, then press the ENTER button.
Press the or buttons to select the desired PIP window position.
Press the
ENTER buttons.
The Double ( ), Double Wide ( ) mode cannot be selected in Position mode.
Changing the Size of the PIP Window
7. Press the or buttons to select “Size”, then press the ENTER button.
Press the
or buttons to select the desired size of the PIP window.
Press the ENTER button.
Press the
EXIT button to exit.
If main picture is in PC mode, Size is not available.
• You may notice that the picture in the PIP window becomes slightly unnatural when
you use the main screen to view a game or karaoke.
• You can adjust picture position only by using the size menu.
Press the SOURCE button on the remote control to select a signal from an external source PIP.
Press the POSITION button on the remote control to
change the position of the PIP screen.
Press the CH buttons on the remote control to change the channels in the PIP screen.
BN68-01001W-00Eng.qxd 7/24/06 8:04 PM Page 22
To Next Page
Loading...
