Access Point Select
You can select the IP sharer to use when using a wireless network.
1, Press the MENU button to display the menu.
Press the _, or _' button to select "Setup", then press the ENTER _ button.
2, Press the _, or T button to select "Wireless Network Setup", then press the
ENTER _ button.
3=
Press the A or T button to select "Access Point Select", then press the
ENTER _ button.
>- The wireless Access Points that exist in you area are searched and
displayed in the Access Point List.
4=
Press the _, or T button to select the Access Point to use. Then press the
ENTER _ button.
>- If a wireless Access Point is not in the Access Point list, press the Red
button.
>- When the connection is made, you will be returned to the screen
automatically.
>- If you selected an Access Point that requires security authentication,
enter the security key.
>- You can enter up to 26 characters for a security key.
if you have selected an Access Point with a security authentication:
- The Security Key input screen appears.
- Enter the security key and press the ENTER _ button.
- Using the Remote Control Buttons on the Security Key Input Screen
Wheel
Moves the selection up/down/left/right.
(A/v/_/_.)
ENTER _ Enters (Inputs) the selected character.
RED " Switchbetween Upper- and Lower-Case
........................................................................................................................Letters
You can delete an already entered
GREEN
character.
Press this button to finish entering the
BLUE
security key.
To Next Page
Loading...
