55
Using MDC
Chapter 04
Conguring Settings for Multi Control
MENUm→ System → Multi Control → ENTERE
Assign an individual ID to your product.
Conguring settings for Multi Control
•
ID Setup
Assign an ID to a set. (Range: 0~99)
Press
▲
/
▼
to select a number, and press
E
.
•
ID Input
Enter the ID number of the product connected to the input cable for input signal reception.
Enter the number you want using the number buttons on the remote control.
•
MDC Connection
Select a method to connect to MDC to receive the MDC signal.
-
RS232C MDC
Communicates with the MDC via a RS232C MDC cable.
-
RJ45 MDC
Communicates with the MDC via an RJ45 MDC cable.
―
If MDC Connection is set to RJ45 MDC and the product is powered off, only the WOL function will be enabled. MDC communication will not be available.
―
The WOL function is enabled only when MDC Connection is set to RJ45 MDC.
Wake On LAN(WOL):
This feature allows you to power on the
product by sending a pre-determined
command from an external system to the
product over a network.
Make sure the network is capable of data
communication with the PC that sends
the command to the product. Ensure you
have a program that can generate Wake
on LAN signals.
To Next Page
Loading...
