English - 17
08
TECHNICAL SPECIFICATIONS
Problem Cause Action
Turntable
While turning, the
turntable comes
out of place or
stops turning.
There is no roller
ring, or the roller
ring is not properly
in place.
Install the roller ring
and then try again.
The turn table
drags while
turning.
The roller ring is
not properly in
place, there is too
much food, or the
container is too
large and touches
the inside of the
microwave.
Adjust the amount of
food and do not use
containers that are too
large.
The turn table
rattles while
turning and is
noisy.
Food residue is
stuck to the bottom
of the oven.
Remove any food
residue stuck to the
bottom of the oven.
If interference is detected by the oven’s microprocessor, the
display may be reset. To solve this problem, disconnect the
power plug and reconnect it. Reset the time.
If the above guidelines do not enable you to solve the problem,
then contact your local SAMSUNG customer service centre.
Please have the following information read.
•
The model and serial numbers, normally printed on the rear
of the oven
•
Your warranty details
•
A clear description of the problem
Then contact your local dealer or SAMSUNG after sales service.
technical specifications
SAMSUNG strives to improve its products at all times. Both the
design specifications and these user instructions are thus subject to
change without notice.
Model
ME71A
Power source 230 V
~
50 Hz
Power consumption
Microwave 1150 W
Output power 100 W / 800 W (IEC-705)
Operating frequency 2450 MHz
Magnetron OM75S(31)
Cooling method Cooling fan motor
Dimensions (W x H x D)
Outside (Include Handle)
Oven cavity
489 x 275 x 349 mm
330 x 211 x 309 mm
Volume 20 liter
Weight
Net 11.5 kg approx
ME71A_SV_DE68-03794R-01_EN.indd 17 2/22/2017 5:47:37 PM
To Next Page
Loading...
