Samsung ML-2545 - Maintenance and Supply Safety Precautions

Safety information_ 5
Warning
Do not place the machine in an area with dust, humidity, or water leaks.
►This could result in electric shock or fire.
Caution
Before moving the machine, turn the power off and
disconnect all cords.
Then lift the machine:
• If the machin
e weighs under 20 kg (44.09 lbs), lift with
1 person.
• If the machin
e weighs 20 kg (44.09 lbs) - 40kg (88.18
lbs), lift with 2 people.
• If the machine weighs more than 40 kg (88.18 lbs), lift
with 4 or more people.
►The machine could fall, causing injury or machine
damage.
Use only No.26 AWG
a
a.AWG: American Wire Gauge
or larger, telephone line cord, if
necessary.
►Otherwise, it can cause damage to the machine.
Do not place the machine on an unstable surface.
►The machine could fall, causing injury or machine
damage.
Do not put a cover over the machine or place it in an
airtight location, such as a closet.
►If the machine is not well-ventilated, this could result
in fire.
The machine should be connected to
the power level which is specified on the label.
►If you are unsure and want to check the power level
you are using, contact the electrical utility company.
Make sure you plug the power cord into a grounded
electrical outlet.
►Otherwise, this could result in electric shock or fire.
Do not overload wall outlets and extension cords.
►This can diminish performance, and could result in
electric shock or fire.
Use the power cord supplied with your machine for safe
operation. If you are using a cord which is longer than 2
meters (6 feet) with a 110 V machine, then the gauge
should be 16 AWG or larger.
►Otherwise, it can cause damage to the machine, and
could result in electric shock or fire.
Maintenance / Checking
Caution
Unplug this product from the wall outlet before cleaning the
inside of the machine. Do not clean the machine with
benzene, paint thinner or alcohol; do not spray water
directly into the machine.
►This could result in electric shock or fire.
• Do not remove any covers or guards that are
fastened with screws.
• Fuser units should only be repaired by a certified
service technician. Repair by non-certified
technicians could result in fire or electric shock.
►The machine should only be repaired by a Samsung
service technician.