Samsung MM-J4 - Clock Setting and CD Playback; Setting the System Clock; Basic CD Playback and Track Selection

our system is equipped with a clock which allows you to turn
your system on and off automatically.
You should set the clock:
When you first purchase the micro-component system
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
Switch the system on by pressing Standby/On ( )
Press TIMER /CLOCK twice.
Result:
CLOCK is displayed.
Press PROGRAM /SET.
Result: The hour flashes.
To... Press...
Decrease the hours
..............................................
Increase the hours
..............................................
When the correct hour is displayed, press PROGRAM /SET.
Result:
The minutes flash.
To... Press...
Decrease the minutes
......................................
Increase the minutes
...........................................
When the correct time is displayed, press PROGRAM /SET.
Result:
The clock starts and is displayed, even when the system is in
standby mode.
You can display the time, even when you are using another
function, by pressing TIMER /CLOCK once.
Adjust the volume according to needs with the following procedures.
Press the VOLUME+,- button or turn the VOL. + or
– knob .
If it is desired to pause while the playback is processing, press the
CD() button.
Press the CD( ) button once again to play back again.
To stop playback, press the Stop ( ) button.
GB
10
Setting the Clock
1
2
3
4
5
6
7
Do not use CDs of irregular shapes like heart or octagon shapes.
The performance of the player may be degraded.
Press the CD( )button on the main unit and select CD.
Open the CD door by pushing on the top of the main unit marked
PUSH OPEN ().
Result
: The CD door is opened.
Place the CD on the compartment so that the CD label faces upward.
Close the CD door.
Result
: Number of tracks and the total playback time are shown on
the display.
Press the CD( ) button to playback.
1
2
3
4
5
7
8
6
Listening to a Compact Disc
You can select the track you wish to listen to, either when the
compact disc player is stopped or when a disc is playing.
To start playback at the beginning of the... Press...
Next track
.....................................................................
once
Current track
.................................................................
once
Previous track
................................................................
twice
Track of your choice
......................................................
or the
appropriate number of
times.
Selecting a Track
When listening to a compact disc, you can quickly search for a
specific music passage on a track.
To search through the tracks... Press and hold down...
Forwards
.........................................................
for at least one second
Backwards
.........................................................
for at least one second
It is recommended that you turn the volume down before using
this function.
Searching for a Specific Music
Passage on a CD
CD
VOLUME
TUNING
.
1,5,7
8
CD
VOLUME
TUNING
6
CD
TUNER
BAND
MO/ST
TIMER/CLOCK TIMER ON/OFF
AUX
PROGRAM/SET REP. A B
SLEEP
EQ/S.BASS TAPE SPEED
MUTE
REV.MODE
SHUFFLE COUNTER RESET
CD
TAPE
SLEEP
EQ/S.BASS TAPE SPEED
REPEAT
TUNING
MODE
VOLUME
TUNING
+10
REV.MODE
SHUFFLE COUNTER RESET
2
1
3,5,7
4,6
4,6
MM-J4-RDS(GB no) 9/19/04 9:21 Page 10