18
GB
Connecting Headphones
You can connect a set of headphones to your micro
component system so that you can listen to music or radio
programs without disturbing other people in the room.
The headphones must have a 3.5 mm connector or
appropriate adaptor.
Connect the headphones to the Phones connector on the rear panel
(or top right corner).
Result: The loudspeakers are no longer used for sound output.
Prolonged use of headphones at a high volume may damage your
hearing.
You can set the system to switch off automatically.
Example
: You wish to fall a sleep to music.
Press SLEEP on the remote control.
Result
: The following indications are displayed:
Press SLEEP one or more times to indicate how long the system should
continue playing before it switches off:
At any time, you can:
Check the remaining time by pressing SLEEP
Change the remaining time by repeating Steps 1 and 2
To cancel the sleep timer function, press SLEEP one or more times until
OFF is displayed and the word SLEEP disappears.
Sleep Timer
CD
TUNER
BAND
MO/ST
TIMER/CLOCK TIMER ON/OFF
AUX
PROGRAM/SET REP. A B
SLEEP
EQ/S.BASS TAPE SPEED
REV.MODE
SHUFFLE
COUNTER RESET
90 MIN 60 MIN 45 MIN
OFF 15 MIN 30 MIN
1
2
3
1,2,3
MUTE Function
You can turn the sound off temporarily.
Example
: You wish to answer a telephone call.
Press MUTE.
To switch the sound back on (at the same volume as before), press
MUTE again, or press the VOLUME +, - button.
1
2
TUNER
BAND
MO/ST
TIMER/CLOCK TIMER ON/OFF
AUX
PROGRAM/SET REP. A B
SLEEP
EQ/S.BASS TAPE SPEED
MUTE
REV.MODE
SHUFFLE
COUNTER RESET
Microphone Function (option)
The microphone enables the user to mix in his or her vocals to
sing -along with the music.
Preparation
Plug the microphone with a 3.5mm jack into microphone terminal.
MM-J4-RDS(GB no) 9/19/04 9:21 Page 18
To Next Page
Loading...
